dimmer cll ch.4 - Cantalupi

POWER IN A DIMMER

Led Light Control

ORDER CODE:

CE DIM CH4 MOD
CE DIM CH4 DMX
CE DIM CH4 KNX

dimmer dimensions
Features

dimmer cll ch.4 features

  • Power Supply:
    24 VDC (Voltage range 10÷52 VDC ).
  • Current consumption:
    50 mA (No Load on output).
  • Type of LEDs controlled:
    LED / StripLED(Monochromatic; RGB; RGB+W)
  • Other type of load controllable:
    incandescent and halogen lamps
  • N° Input: 4+4, “dry-contact” type
    N° 4 pushbutton (Normally Open) type for output control
    N° 4 pushbutton (Normally Open) type for managing default scenarios
    N° Output: 4
  • Max Output Power for each channel:
    140 W @24 VDC
  • Dimmer mode: PWM @300 Hz
  • Hardware RS 485
  • Protocol: DMX512; MODBUS; EIB-KNX
  • Operating channel LED:
    for each input and output channel
  • Electric Protection (from external spikes):
    25A fuse not removable
  • Electronic Protection (for output channels):
    auto resettable electronic fuse for each channel. A self- limiting current flows rises when current overload (or output LED shortcut) occurs
  • Terminals:
    removable; multicore wires (up to 2,5 mm2 / 12 AWG)
  • Protection level:
    IP 20
  • Materiale (case):
    v-0; (according UL-94, on request)
  • Accordance technical law: 
    CE for marine device (CEI-EN 60945 4th ed.)
  • Dimensions WxHxD (mm) / DIN modules:
    160x98x60 / 9 DIN modules
  • Mounting: DIN; Wall
dimmer usage configuration

Features

  • Default scenarios controlled by traditional pushbutton: 
    ALL ON; ALL OFF; ALL 50%; ALL 10%
  • Dynamic White control:
    provides white mix for all colours temperatures supported by lamps.
  • Soft start (ramp light):
    provides proportional increase (decrease) of the brightness until max (min) value set.Single pushbutton can control up to 4 channels.
  • Single Pushbutton increasing power:
    1 Master can control up to 128 slaves.
  • Push-Pull Control System:
    avoid random flickering when channel are heavy loaded about max capacity

Additional functions are available (by MODBUS-RTU only) to increase creativity of designers and customers experience about emotions of lights.

(further)
Function:
Read
for monitoring
system feedback
Write:
1) Selected Brightness ok ok
2) Min. brightness by pushbuttons ok ok
3) Max. brightness by pushbuttons ok ok
4) Lights variation speed ok ok
5) Pushbutton inhibition ok ok
6) Latch Register Light Intensity ok ok
7) RGB: enhanced mode control ok ok
8) Voltage Power Supply ok na
9) Temperature internal case ok na
DOCUMENTS
Dimmer CLL ch.4
Full Datasheet


Share on FacebookShare on LinkedInPrint this pageTweet about this on TwitterShare on Google+